Air breaker NA1-2000X-1600M/4P MO-WD AC220/230 TP
I. General
NA1 series air circuit breaker is suitable for the circuit of AC 50Hz/60Hz with rated service voltage 400V, 690V and rated service current up to 6300A. It is mainly used to distribute electric energy and protect circuits and electric equipment against over-load, under-voltage, short-circuit and singlephase earthing fault. With intelligentized and selective protection functions, the breaker can improve the reliability of power supply, and avoid unnecessary power failure. The breaker is applicable for power stations, factories, mines (for 690V) and modern highbuildings, especially for the distribution system of intelligentized building.
Standard: IEC/EN 60947-2.
II. Operating conditions
- Temperature condition: -5℃~40℃; the average value within 24h shall not exceed +35℃ (special situation excluded);
- Altitude:≤2000m;
- Pollution grade: Grade 3;
- Air conditions: At mounting site, relative humidity not exceed 50% at the max temperature of +40℃,higher relative humidity is allowable under lower temperature, RH could be 90% at +20℃, special measures should be taken to occurrence of dews;
- Note: Without the intelligent controller, the breaker functions as a switch-disconnector
III. Select product code
IV. Structure
V. Main technical parameter
VI. Dimensions and connection
VII. Secondary circuit wiring
Wiring the secondary circuit according to electric principle diagram.
Note: Bolts, nuts, gaskets shouldn't be left inside the drawer seat to avoid being blocked.
VIII . Application
Air breaker NA1 is used to switch and protect electrical equipment such as overload, short circuitCommonly used in:
- Civil and industrial electrical works
- Main circuit breaker for large outdoor power line system
The NA1 air breaker offers efficiency, stability and flexibility. This is a safe solution in the building or the national power grid.